vortiprop.blogg.se - Connecting garmin homeport to chartplotter

Connecting garmin homeport to chartplotter how to#
Connecting garmin homeport to chartplotter software#

NOTE: If possible, you should meet all of these criteria to prevent this issue when installing a GPSMAP 8×22 or GPSMAP 8×24 Chartplotter.īe careful when cutting the hole to flush mount the device. Method to shade the display using a canopy, window tint, or shroud.

Cooling source on the front and rear of the Chartplotter.If the mounting location for a GPSMAP 8×22 or GPSMAP 8×24 Chartplotter is in direct sunlight and in a horizontal orientation, ensure that the installation location meets as many of the following criteria as possible: You must select a location that allows room for the routing and connection of all cables. To avoid interference with a magnetic compass, you must not mount the device closer to a compass than the compass-safe distance value listed in the product specifications. You should select a location that allows for easy access to all device interfaces, such as the keypad, touchscreen, and card reader, if applicable. You must select a location that is strong enough to support the weight of the device and protect it from excessive vibration or shock. You should mount the device to provide an optimal viewing angle as you operate your boat.When selecting a mounting location, observe these considerations. Using the included hardware and template, you can flush mount the device in the dashboard. Extreme-temperature-induced damage and related consequences are not covered by the warranty. Extended exposure to temperatures exceeding the specified temperature range, in storage or operating conditions, may cause device failure. The temperature range for this device is listed in the product specifications. This device should be mounted in a location that is not exposed to extreme temperatures or conditions. ◦ 7.2 mm ( /32 in.) drill bit, if using the nut plate ◦ 3.6 mm ( 9/64 in.) drill bit, if using the nut plate ° 3.2 mm ( 1/8 in.) drill bit, if using wood screws POWER Power NETWORK Garmin Marine Network HDMI IN HDMI` in HDMI OUT HDMI out CVBS IN Composite video in NMEA 0183 NMEA’ 0183 and audio out USB Micro-USB to connect a compatible Garmin card reader, or to connect and control a computer using the Chartplotter touchscreen NMEA 2000 NMEA 2000′ network ENGINE/J1939 J1939 engine network The connectors and locations vary based upon the model.

Connecting garmin homeport to chartplotter how to#

For the instructions on how to update the software, see the owner’s manual at /manuals/GPSMAP8400

Connecting garmin homeport to chartplotter software#

You may need to update the Chartplotter software after installation.

Go to for help and information, such as product manuals, frequently asked questions, videos, and customer support.

If you experience difficulty during the installation, contact Garmin ® Product Support. Read all installation instructions before proceeding with the installation. When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel. For the best possible performance, the device must be installed according to these instructions.